- Carrera Slot Car Track Layout Software
- Carrera Slot Car Track Layout Software
- Slot Car Track Layout Software
Carrera Slot Car Track Layout Software
Carrera Slot Car Track Layout Software
Kuch kehta hai yeh sawan karaoke. 'Think your slot car track is awesome? You haven't seen awesome till you've looked at the White Lake Formula 1 Ring, a race track that takes' 'Musings about cars, design, history and culture - Automobiliac - The Slot Car Track to end all Slot Car Tracks' 'I saw this amazing setup via the New York Times, and had to share. ModelMotorist.Com provides an extensive slection of HO scale slot and slotless track layout plans. Scale Slot Car Track. Scale Slot Track Layout. The easiest way to design a track though is to use slot car track design software. Design software allows you to try numerous configurations until you have a track you really like. If you have a large inventory of HO scale slot car track sections on hand you can physically lay out your proposed track design ideas on your table and try them out. Star wars despecialized stream.
Slot Car Track Layout Software
With the base covered in felt you can now lay the track. I started by cleaning my track and polishing all the connections, this step will save some dead track section problems later.
I put the whole layout together and lined up the whole thing, getting rid of any gaps and making sure it was cantered on the base.
You will need to stand up the over passes now, and make your supports, to help hold the track together I used AFX track clips to keep the sections tight.
My supports are made from 3/4' particle board scraps cut the same width as the track used, The thinner ones near the start and stop of the over passes are 1/8' solid cardboard and 1/4' cork.
The longer over pass supports are screwed down to the door from below with long screws. The thin ones are simply fitted under the track before its screwed down.
After you get the over pass secured, screw down all the flat track, this will take some time, but once done you never have a problem with it coming loose.
I also slightly beveled the taller support to give it a slight banking, This will make the curve faster.
I put the whole layout together and lined up the whole thing, getting rid of any gaps and making sure it was cantered on the base.
You will need to stand up the over passes now, and make your supports, to help hold the track together I used AFX track clips to keep the sections tight.
My supports are made from 3/4' particle board scraps cut the same width as the track used, The thinner ones near the start and stop of the over passes are 1/8' solid cardboard and 1/4' cork.
The longer over pass supports are screwed down to the door from below with long screws. The thin ones are simply fitted under the track before its screwed down.
After you get the over pass secured, screw down all the flat track, this will take some time, but once done you never have a problem with it coming loose.
I also slightly beveled the taller support to give it a slight banking, This will make the curve faster.